From a route to a ride estimate
Working Out combines the route with your power reference points to compare strategies. It does not predict your actual arrival to the minute.
Route, rider and bike
The engine splits the imported route into segments and smooths gradients over 250 metres to reduce altitude noise. Rider and bike mass, FTP, riding position, rolling resistance and the speed cap affect the result. A provisional FTP remains an assumption. Without a personal power-duration curve, the software estimates one from FTP; it does not measure your endurance.
Power and resistance
Segment speed balances power after transmission losses against gravity, rolling resistance and aerodynamic drag. Gradient, mass, effective drag area, air density and wind matter. Descending speed is capped. Braking, bends, traffic and individual accelerations are not fully reconstructed.
Effort and scenarios
Targets differ for flats, short climbs, long climbs and descents. They are expressed as fractions of FTP and adjusted using fatigue and shelter assumptions. Weighted power uses a rolling 30-second average and fourth-power weighting. Comparison with your power-duration curve is a consistency indicator, not medical advice.
The probable scenario uses the reference settings. The cautious scenario applies a power factor of 0.94 and weather factor of 1.10; the ambitious scenario uses 1.05 and 0.90. These are model conventions, not measured probabilities or confidence intervals.
Average speed and arrival
Moving average speed is distance divided by moving time. Stops are excluded. Total time adds only the stops you enter; arrival time adds that total to departure. For example, 100 km in 4 moving hours is 25 km/h. With 30 minutes of stops, the ride takes 4 hours 30 minutes.
Compare estimates with real rides and refine your inputs. Published physics models provide a foundation, but do not independently validate Working Out. Read the limitations and sources.
